CPC30220 Certificate III in Carpentry

You are required to develop, in consultation with relevant personnel, two Job Safety Analysis (JSA) for general hazards. Each JSA should be for a different job task and on a different work site, as allocated by your Assessor.

Prior to commencing each work task, you must revise each JSA, identify changed conditions and where appropriate, amend the JSA to reflect changed hazards and risk control strategies

All work must be performed to the standard required in the workplace and must meet the requirements of work health and safety (WHS), the National Construction Code (NCC), Australian Standards, Commonwealth and state or territory legislation, manufacturers specifications, and environmental plans and obligations.

Part 1: Prepare JSA

Review the job task, work site and compliance requirements.
Review requirements of work health and safety legislation for preparation of the JSA.
Break the job task into logical steps, determine tools, equipment, plant and materials to be used for each step.
Identify work site and task-related hazards and levels of risk relating to each step.
Inspect work site and identify hazards relevant to job task.
Determine and record level of risk for each identified hazard.
Apply hierarchy of controls to determine risk control strategies for each hazard in each step of the job task, discuss and confirm with relevant personnel.
Submit JSA (x2)
Simulation Task 2 Observation Identify construction work hazards and select risk control strategies

Part 1 Complete the following:

Attach two completed Job Safety Analysis to this section of your Assessment Workbook, labelled as Unit Code and title> Task 2.1 Part 1> Job Safety Analysis> your name and date.

Attach two revised Job Safety Analysis to this section of your Assessment Workbook, labelled as Unit Code and title> Task 2.1 Part 2> Revised Job Safety Analysis> your name and date.

WRITE MY PAPER

CPC30220 Certificate III in Carpentry

Comments

Leave a Reply Cancel reply